Güncel Gönderiler: Makaleler
Toplam kayıt 32, listelenen: 21-32
-
The examination of corrosion behaviors of HAP coated Ti implant materials and 316L SS by Sol-Gel method 1
(Pleiades Publishing, Ltd, 2011)In this research, hydroxyapatite (HAP) coatings have been produced on Ti, Ti6Al4V alloy and 316L stainless steel substrates by sol–gel method. (NH4) H2PO4 is taken as P precursor and Ca(NO3)2 4H2O is taken as Ca precursor ... -
The effect of 3-Methyl 1-Pentyn 3-ol on the corrosion of Al-Si-Cu alloys in acid solutions by using SEM, EDX and AAS
(Pleiades Publishing, Ltd, 2009)In this study, the effect of alloying elements on the corrosion of Al-Si-Cu alloys in H 2 SO 4 and HCl media content 3-methyl–1pentyn–3-ol (3mlp3ol) is investigated by using SEM, EDX, AAS. The effect of active elements and ... -
Formation of deposit and corrosion in Afyonkarahisar geothermal heating system [Afyonkarahisar jeotermal isitma sisteminde oluşan kabuklaşma ve korozyon]
(TMMOB jeoloji müdendisleri odası, 2008)The formation of deposit and corrosion, which was formed depending on the chemical composition of the geothermal water, is one of the most serious problems at the geothermal systems. In this study, ion chromotography (IC) ... -
Tertiary amine methacrylate based polymers as Corrosion Inhibitors in double distilled water. Part I
(Pleiades Publishing, Ltd, 2019)In the current study, the inhibitive performances of tertiary amine methacrlate based water soluble diblock copolymers on the corrosion behaviour of AISI 304 stainless steel were investigated in double distilled water (DDW, ... -
Corrosion behavior of boro-tempered ductile iron
(Springer, May 2010)In this study, the effect of boro-tempering heat treatment on the microstructure and corrosion behavior of unalloyed ductile iron was investigated. The corrosion characteristics of ductile iron have been determined by ... -
Electrochemical corrosion behavior of high velocity Oxy-Fuel (HVOF) superalloy coatings on ductile irons
(Sakarya University Journal of Science, 2019)In this study, alloyed and unalloyed ductile irons (DI) were coated with two different Ni-based superalloy materials by HVOF method. Microstructure and phase analyzes of the coatings were performed by using SEM, EDX, XRD ... -
Effects of CO2 and H2S on corrosion of martensitic steels in brines at low temperature
(Nace International, 2018)Corrosion studies were conducted for martensitic carbon steels in 5 wt% NaCl brine solutions at 4°C and 10 MPa (1,450 psi). These studies simulated different subsurface environments relevant to Arctic drilling. Here, two ... -
Investigation of corrosion and wear behavior of borided AISI P20 steel in micro-wave furnace
(IOP Publishing, 2019)In this study, the effect of microwave boronizing treatment on the corrosion and wear behaviour of boride layer formed on AISI P20 steel have been investigated. The boronizing treatment was carried out using Ekabor-II ... -
Electrochemical corrosion of Ti6Al4V, Ti and AISI 316L SS after immersed in concentrated simulated body fluid
(Pleiades Publishing, Ltd, 2016)The biomimetic method is used to obtain hydroxyapatite (HAP) coatings on Ti6Al4V, Ti and AISI 316L SS substrates. These substrates with different pretreatment surface operations (HNO3, anodic polarization, base-acid) were ... -
Corrosion behavior of 13Cr casing steel in cement-synthetic pore solution exposed to high pressure CO2 and H2S
(The Electrochemical Society, 2015)The electrochemical corrosion behavior of grade L-80, type 13Cr casing steel was investigated in cement-synthetic pore solution (CSPS) exposed to CO2 and H2S using in-situ electrochemical methods and ex-situ surface analyses ... -
Corrosion behaviors of hydroxyapatite coated by electrodeposition method of Ti6Al4V, Ti and AISI 316L SS substrates
(Pleiades Publishing, Ltd, 2013)Electrodeposition method was used to obtain hydroxyapatite (HAP) coatings on Ti6Al4V, Ti and AISI 316L SS substrates. Electrodeposition solution is prepared as Ca(NO3)2 ⋅ 4H2O and (NH4)H2PO4. Additionally, three different ... -
Investigation of Corrosion Behaviours Hydroxyapatite (HAP) coated Ti6Al4V Implants by Using Electrochemical Deposition Method
(2018)In this research, hydroxyapatite (HAP) has been coated on the Ti6A14V alloy surface by electrophoresis method. In this electrophoresis method, NH4H2PO4 is taken as P precursor and Ca (NO3)2.4H2O is taken as Ca precursor ...